avec la technique de l'anneau en oignon
numéro d'article 120135T
Aperçu des informations les plus importantes
Élément d'étanchéité : caoutchouc EPDM respectueux de l'environnement
.
Largeur du joint : 40mm
Plaques de pression, vis, écrous : V2A
Plaques d'impression : argentées
M6
La Commission européenne
5 Nm (tubes de milieu indéformables)
100 mm
La durée de vie de l'appareil est de trois ans.
Sans bouchon intérieur : 18 - 20 mm
1er anneau : 21 - 25 mm
2. Anneau : 26 - 30 mm
3e anneau : 31 - 35 mm
3.
3ème anneau : 31 - 35 mm
4.
4ème anneau : 36 - 40 mm
4.
5ème anneau : 41 - 45 mm
5.
6ème anneau : 46 - 50 mm
6.
7. anneau : 51 - 55 mm
7. anneau : 56 - 60 mm
8. anneau : 56 - 60 mm
8. anneau : 56 - 60 mm
9. Anneau : 61 - 65 mm
Adjust the sealing insert of the MASTER-Ring Multi split version to the diameter of the media line. To do this, push the required rings backwards through the seal.
Remove the locking clip of the MASTER-Ring Multi split version
Open the gasket on the side of the puzzle pieces.
Place the MASTER-Ring Multi split version around the installed pipe.
Close the gasket and reinstall the locking clip and close it as well.
Push the seal into the annular gap.
Tighten the screws crosswise through one turn.
Tighten the screws to the specified max. torque. (Ø 100/150/200 = 5Nm; Ø250 = 10Nm).
Check the torque after 1-2 hours and retighten the screws if necessary.
Contactez nous
We are happy to answer your questions