z bentonitu sodného
číslo článku 010012
MASTERSTOP "LONG TIME" bentonitová bobtnající páska pro bezpečné utěsnění stavebních spár a prostupů v betonových konstrukcích proti vnikání vody. Pronikání vody je zabráněno bobtnáním a bobtnavým tlakem, který vzniká během procesu bobtnání.
MASTERSTOP LONG TIME bentonitová bobtnající páska je těsnění, které může ve vodě bobtnat. Skládá se z jemně mletého, vysoce bobtnavého jílového minerálu (bentonitu sodného), vloženého jako pojivo do matrice z nevulkanizované pryže. Pro lepší odolnost proti povětrnostním vlivům je potažen filmem, který se v betonu sám rozpouští. Přidat do seznamu oznámeníPřehled nejdůležitějších informací
Bentonit sodný
Hladký
plastové
V normální vodě (PH 7)
až 340 %.
až 150 % v kapalinách, které silně napadají beton
až 290 % v alkalických kapalinách
Ne
Ja
Ne
Ja
ETA - 16 / 0735
Osvědčení o zkoušce obecného stavebního úřadu (AbP), MFPA Lipsko
Číslo: P-SAC 02 / 5.1 / 15-253
cca 10 dní
provádí se přibližně 6-7 dní po betonáži
Ja
Třídu A použijte pro třídy zatížení 1 a 2 podle pokynů WU
Since the MASTERSTOP "LONG TIME" is supplied with a protective sheating, the swelling tape can
only be fastened by using a special swelling tape grid.
The substrate must be clean, dry and free of loose parts.
Apply the MASTERSTOP "LONG TIME" in the middle of the joint to the concrete surface and fix it.
The later concrete cover must be at least 8cm.
The swelling tape must be bordered by reinforcement on both sides.
Minimum distance to the reinforcement: 5cm.
Place the swelling tape grid carefully over the swelling tape without damaging the protective sheating.
The grid must only be nailed on through the side wings.
Fasten with suitable nails either by hand or mechanically with a bolt-firing tool.
The distance between nails should not exceed 25 cm in the longitudinal direction of the swelling tape.
At the beginning of the tape and if tape sections are used, pull back the protective sheating approx. 5 cm, cut off the swelling tape and fold over the extra length of sheating to prevent contact with water.
In the corners, the swelling tape grid must be released in order to ensure a continuous firm fixation on the substrate.
In the case of butt joints in the straight line and the use of swelling tape grids, the joints of swelling tape and swelling tape grid should always be made in a staggered position.
Status: 23.03.2022
Příslušenství
vhodné příslušenství
Mřížka na opasek pro MASTERSTOP "LONG TIME" 25/20, délka 1 m ...
Délka 42 mm s velkým kotoučem ...
Délka 40 mm s kotoučem ...
Podobné produkty
Podobné produkty najdete zde.
Toto je test...
Kontaktujte nás
Rádi zodpovíme vaše dotazy