de bentonita sódica
número de artículo 010012
MASTERSTOP Cintas expansivas de bentonita
MASTERSTOP "LONG TIME" cinta hinchable de bentonita para el sellado seguro de juntas de construcción y penetraciones en estructuras de hormigón contra la entrada de agua. La penetración de agua se impide mediante el hinchamiento y la presión de hinchamiento creada durante el proceso de hinchamiento.
MASTERSTOP LONG TIME bentonite swelling tape es una junta que se hincha con el agua. Consiste en un mineral de arcilla (bentonita sódica) finamente molido y altamente hinchable, incrustado como aglutinante en una matriz de caucho no vulcanizado. Para una mayor resistencia a la intemperie, se recubre con una película que se autodisuelve en el hormigón. Añadir a la lista de avisosLa información más importante de un vistazo
Bentonita sódica
Suave
plástico
Hasta 340 % en agua normal (PH 7)
hasta 150 % en líquidos que atacan fuertemente el hormigón
hasta 290 % en líquidos alcalinos
No
Ja
No
Ja
ETA - 16 / 0735
Certificado de prueba general de la autoridad de construcción (AbP), MFPA Leipzig
No.: P-SAC 02 / 5.1 / 15-253
aprox. 10 días
Se realiza aprox. 6-7 días después del hormigonado
Ja
Utilizar clase A para clase de carga 1 y 2 de acuerdo con la directriz WU
Since the MASTERSTOP "LONG TIME" is supplied with a protective sheating, the swelling tape can
only be fastened by using a special swelling tape grid.
The substrate must be clean, dry and free of loose parts.
Apply the MASTERSTOP "LONG TIME" in the middle of the joint to the concrete surface and fix it.
The later concrete cover must be at least 8cm.
The swelling tape must be bordered by reinforcement on both sides.
Minimum distance to the reinforcement: 5cm.
Place the swelling tape grid carefully over the swelling tape without damaging the protective sheating.
The grid must only be nailed on through the side wings.
Fasten with suitable nails either by hand or mechanically with a bolt-firing tool.
The distance between nails should not exceed 25 cm in the longitudinal direction of the swelling tape.
At the beginning of the tape and if tape sections are used, pull back the protective sheating approx. 5 cm, cut off the swelling tape and fold over the extra length of sheating to prevent contact with water.
In the corners, the swelling tape grid must be released in order to ensure a continuous firm fixation on the substrate.
In the case of butt joints in the straight line and the use of swelling tape grids, the joints of swelling tape and swelling tape grid should always be made in a staggered position.
Status: 23.03.2022
Accesorios
accesorios adecuados
Rejilla de cinturón para MASTERSTOP "LONG TIME" 25/20, longitud de 1 m ...
Longitud 42 mm con disco grande ...
Longitud 40 mm con disco ...
Productos similares
Puede encontrar productos similares aquí.
Esto es una prueba...
Contacto
Estaremos encantados de responder a sus preguntas