dalla bentonite di sodio
numero di articolo 010012
Nastri ad espansione bentonite
MASTERSTOP "LONG TIME" nastro bentonitico rigonfiante per la sigillatura sicura di giunti e penetrazioni nelle strutture in calcestruzzo contro l'ingresso di acqua. La penetrazione dell'acqua è impedita dal rigonfiamento e dalla pressione che si crea durante il processo di rigonfiamento.
Il nastro bentonitico MASTERSTOP LONG TIME è una guarnizione in grado di gonfiarsi in acqua. È costituito da un minerale argilloso (bentonite di sodio) finemente macinato e altamente rigonfiabile, inserito come legante in una matrice di gomma non vulcanizzata. Per una migliore resistenza agli agenti atmosferici, è rivestita da una pellicola che si autodissolve nel calcestruzzo. Aggiungi all'elenco degli avvisiLe informazioni più importanti in un colpo d'occhio
Bentonite di sodio
Liscio
plastica
Fino al 340 % in acqua normale (PH 7)
fino al 150 % in liquidi che attaccano fortemente il calcestruzzo
fino al 290 % in liquidi alcalini
No
Ja
No
Ja
ETA - 16 / 0735
Certificato di collaudo dell'autorità edilizia generale (AbP), MFPA Leipzig
N.: P-SAC 02 / 5.1 / 15-253
circa 10 giorni
viene effettuato circa 6-7 giorni dopo la messa in opera del calcestruzzo
Ja
Utilizzare la classe A per le classi di carico 1 e 2 secondo le linee guida WU
.
Since the MASTERSTOP "LONG TIME" is supplied with a protective sheating, the swelling tape can
only be fastened by using a special swelling tape grid.
The substrate must be clean, dry and free of loose parts.
Apply the MASTERSTOP "LONG TIME" in the middle of the joint to the concrete surface and fix it.
The later concrete cover must be at least 8cm.
The swelling tape must be bordered by reinforcement on both sides.
Minimum distance to the reinforcement: 5cm.
Place the swelling tape grid carefully over the swelling tape without damaging the protective sheating.
The grid must only be nailed on through the side wings.
Fasten with suitable nails either by hand or mechanically with a bolt-firing tool.
The distance between nails should not exceed 25 cm in the longitudinal direction of the swelling tape.
At the beginning of the tape and if tape sections are used, pull back the protective sheating approx. 5 cm, cut off the swelling tape and fold over the extra length of sheating to prevent contact with water.
In the corners, the swelling tape grid must be released in order to ensure a continuous firm fixation on the substrate.
In the case of butt joints in the straight line and the use of swelling tape grids, the joints of swelling tape and swelling tape grid should always be made in a staggered position.
Status: 23.03.2022
Accessori
accessori adatti
Griglia per nastro ondulato per MASTERSTOP "LONG TIME" 25/20, lunghezza 1 m ...
Lunghezza 42 mm con disco grande ...
Lunghezza 40 mm con disco ...
Prodotti simili
Potete trovare prodotti simili qui.
Questo è un test...
Contattateci
Siamo lieti di rispondere alle vostre domande